FAQs Häufige Fragen an uns

Fragen dazu Fragen dazu

All FAQs (1768 total: showing 1621-1640)

Can the CR800, CR850, CR1000, or CR3000 upload to an FTP site on scheduled intervals?
Is it possible to connect the CR800, CR850, CR1000, or CR3000 to a SCADA system through a Modbus RS-485 protocol?
How can the CR800, CR850, CR1000, or CR3000 be configured as a Modbus RTU server?
Is it possible to overwrite an existing array using a CR850?
Can the NL201 be put into bridge mode via the settings of a CR800 or CR850?
Can the CR850 be programmed to show information in the display without using the keyboard?
Can a new program be installed on a datalogger using a laptop and PC200W?
When no excitation is commanded, are the voltage excitation ports on the datalogger isolated from the datalogger ground?
Instead of saving the data of a CRBasic data logger to one large file, how can it be saved in daily, hourly, or half-hourly files?
If a computer does not have any serial ports, how can software (such as LoggerNet, PC400, PC200W, or Device Configuration Utility) talk to the datalogger?
Can external devices be switched on and off using a datalogger?
If a device or sensor is not available for selection in the Short Cut program, how can it be added?
Can the datalogger be damaged by wiring the sensors to the wrong ports?
How can a floating point value be cast as a long integer?
How can data that has been transmitted from a datalogger to LoggerNet then be transmitted to a webhost that displays the data graphically?
Is there a way to only record measurements during the daytime and put the datalogger in sleep mode during the nighttime to conserve power?
What is checked during the calibration of a Campbell Scientific datalogger?
Is it possible to use LoggerNet Admin software to connect to, and display data from, multiple dataloggers?
Can a datalogger be contained in a waterproof enclosure?
What does the PreserveVariables instruction do?

Vorhergehendes Nächstes