FAQs Häufige Fragen an uns

Fragen dazu Fragen dazu

All FAQs (1768 total: showing 1601-1620)

Is using Ethernet the best option to connect a CR800 to a PC that is 500 to 700 feet away?
How many SDI sensors can the CR800 or CR850 handle?
If a datalogger is accidentally plugged into a 24 Vdc power source, what can be done to correct the situation?
For redundancy purposes, is it possible to have two GSM modems connected to a CR800 or CR850 with each modem on a different cellular provider?
What software is necessary to modify a program built with LoggerNet for an isolated CR800 or CR850?
How can multiple programs for different sensors be sent to a single CR800 or CR850 datalogger?
Can the CR800 be programmed through either a mountable or portable keyboard display?
Is there an Ethernet module available for the CR800 or CR850?
What is the maximum current that the control port of a CR800, CR850, or CR1000 can source without causing damage?
Does the CR800 or CR850 work with a 2 kHz (maximum) burst mode for the VoltDiff() instruction like the CR1000 does?
Can the battery on the CR800 or CR850 be changed by the user?
How can several SDI-12 instruments be wired to a single datalogger terminal?
Can a CR800 wiring panel be used on a datalogger other than the original datalogger?
What is the maximum supply voltage of a CR800 or CR850 without damaging the data logger?
Why do the example programs for the WXT520 use a scan rate of 5 seconds?
Why do the values from the WXT520 seem to be out of order?
If the wind speed on the WXT520 constantly reads 0, what should be done?
Is LoggerNet software needed to download the data from a datalogger remotely?
Can the constants located within the ConstTable/EndConstTable instructions be edited?
Can the display timeout and contrast be programmed by the CRBasic Editor?

Vorhergehendes Nächstes