Überblick
The CS11 monitors ac current along an electrical wire. It outputs a millivolt signal that many of our dataloggers can directly measure.
Lesen Sie mehrFunktionen und Vorteile
- Ideal applications include motor or generator load conditions, efficiency studies, intermittent fault detection, and rough submetering
- Sensor is external to the wire jacket and has no direct electrical connection to the system
Bilder
Technische Beschreibung
The CS11 uses CR Magnetic's CR8459 Current Transformer to detect the ac current along an electrical wire using the magnetic field that is generated by that current. The CS11 is external to the wire jacket and has no direct electrical connection to the system.
The CS11 is recommended for measurements that do not require high accuracy, such as motor or generator load condition monitoring, efficiency studies, intermittent fault detection, and rough submetering.
Spezifikationen
| Measurement Range | 0.15 to 200 A (0.15 to 125 A for CR200X) |
| Frequency | 50 and 60 Hz |
| Insulation Resistance | 100 MΩ (@ 500 Vdc) |
| High Potential | 2000 V |
| Rated Current | 200 A, 125 A (CR200X) |
| Accuracy | Typically ±1% of actual value with provided multiplier (with 10 Ω maximum burden [resistive]) |
| Multiplier | iMult=200 A/1000 mV=0.2 |
| Operating Temperature Range | -25° to +55°C |
| Storage Temperature Range | -25° to +70°C |
| Case Material | Polypropylene resin |
| Construction | Epoxy encapsulated |
| Inner Diameter | 1.9 cm (0.75 in.) |
| Outer Diameter | 4.8 cm (1.89 in.) |
| Height | 1.7 cm (0.67 in.) |
Dokumente
Handbücher
FAQs für
Number of FAQs related to CS11-L: 5
Alle anzeigenWenige anzeigen
-
Connect the red wire to ground rather than its normal location on the CR200(X).
-
Not directly. If the CS11-L is connected to a data logger, the data logger can take the ac measurement and control a solid-state relay based on some threshold within the data logger program. The solid-state relay can then control other relays, solenoids, or motor starters. (Use of a solid-state relay is preferred because the data logger can trigger it with a small 5 Vdc mA signal.)
-
No. The CS11-L is an ac-only sensor.
-
Yes. Three CS11-L sensors can be connected to a datalogger to measure the amperage on each of three phases.
-
The following are some of the features of the CS11-L:
- The quality of the measurements was improved by upgrading the 10 ohm internal resistor.
- The CS11-L is compatible with the CR200(X)-series dataloggers, as well as all of the dataloggers that were compatible with the CS10-L. This allows the CS11-L to replace both the CS10-L and the CS15-L.
- The programming examples were improved to give greater stability to the measurements. On some datalogger models, the ACPower() instruction can be used.
Anwendungsbeispiele
In 1922, when the intact tomb of Tutankhamen was discovered in Egypt's Valley of the......lesen Sie mehr