FAQs Häufige Fragen an uns

Fragen dazu Fragen dazu

All FAQs (1756 total: showing 1721-1740)

Is calibration of the 229-L available?
If several 229-L probes begin returning very low positive and negative values for dT, what might be the cause?
How should the AM25T be used?
Can the AM25T be connected to an analog input channel on a device other than a datalogger, such as a programmable logic controller (PLC)?
How can the datalogger build a text string and send it out the RS-232 port?
Can a point-multipoint network be built using RF401 radios with a base and three remote terminals, a datalogger at each terminal, a COM210 modem, and a remote PC with LoggerNet software?
When trying to start LoggerNet, what might cause the "Unable to start program because the Campbell Scientific communications server is already running" message?
After installing an upgrade to the current version of LoggerNet, why does the Toolbar no longer show all the buttons?
Why is the battery in the BP12 and BP24 assembly taller than the bracket?
Where is the Transformer tool?
What is the stated accuracy for the thermocouple (temperature measurement) in a 229-L Water Matric Potential Sensor?
Can the RF401A be used in an RF400 network?
What is the natural frequency of the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH?
What is SDI-12?
What is the frequency response of the FW05 thermocouple?
Which rain gages does the CS705 work with?
What is the procedure for orienting a wind monitor (05103-L, 05103-45-L, 05305-L, or 05106-L) to the cardinal directions so that the wind direction readings are correct?
Does Campbell Scientific software contain spyware?
What are the options for purchasing LoggerNet 4?
For the UT30, what size pipe is the top mast? If the top mast tapers down to a smaller top piece, what size does it taper down to?

Vorhergehendes Nächstes