FAQs Häufige Fragen an uns

Fragen dazu Fragen dazu

All FAQs (1768 total: showing 1701-1720)

Can the CS511-L be completely immersed?
Is there a connection where the cable can come out of the CS511-L?
How can a data table on the datalogger be deleted using the simplepb.dll library?
If a facility has ordered the RTDAQ software but wants to start using it right away, can a copy of the software be downloaded from the Campbell Scientific website?
Does CRBasic have to be used to program a datalogger? Does a menu-driven program generator exist for the datalogger?
What is the 229-L heating element made of? In an acidic environment, such as copper mine tailings, would the sensor be expected to fail because of corrosion within five years?
What is the optimum calibration frequency for a WindSonic?
Is it possible for a WindSonic to operate in extreme conditions like snow, glacial temperatures, and freezing rain?
Where is the interface cable for the WindSonic?
Can vertical wind speed be measured by rotating the WindSonic 90 degrees?
Can the WindSonic produce an output of 4 Hz or higher frequency?
The WindSonic has the average 1 Hz output of 40 Hz block measurements. What does the 40 Hz block measurement mean?
Is it possible to connect a sonic anemometer and an electronic compass to a smart datalogger to give wind speed and direction on a non-fixed platform?
If data is downloaded to a PC, the resultant “CR1000_Table1.dat” file is, for example, 150 kB in size. Is 150 kB necessarily its size on the CR1000? Is there any type of data compression being used?
Can the CR1000 or CR3000 communicate over TCP/IP?
Can the CR1000 measure 4 to 20 mA signals?
What is the power consumption (mA) of the 05103-L, 05103-45-L, 05305-L, and 05106-L anemometers?
What is the procedure for orienting a WindSonic-L to the cardinal directions, so that the wind direction readings are correct?
Can the CR5000 store data with a rate of 1000 Hz?
Is the 03101-L capable of delivering a 0 to 5 Vdc square wave output for the wind speed?

Vorhergehendes Nächstes