Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.
Question/Topic Posted By Replies
FTP client throught a 3G router with IP protocol Benjamin.vial 6
writing program MJMagaji 3
Not getting good data from my Setra 278 on a new CR300 TedDarby 1
RTMC NAN alarm jarlu 1
Loggernet server crashes trashbk 13
Gill WindObserver 70 ASCII Polar format anbo 0
FtpClient passat 1
SC32A vs. SC32B Rocha 3
Troubleshooting CR6 as Modbus Slave SteveA 3
CS650 on volcanic soils. m.calispa 1
Cannot add/connect CR200X to a new laptop Maggie 1
Retrieve program from cr200w datalogger MJMagaji 5
Switched control port for camera. cellectronic 1
Biral Visibility Sensor SWS100LW CR6 CESPool 0
is it possible to connect cr6 via usb cable directly to remote router usb port ? mortenx 3
CH200 Battery Test State - Qloss Reset to 0 After Completion of Test? Terrapin 0
Windspeed Vic_Campbell 1
Limitar conexión entre datalogger CR1000X y modem HUDHES 9502 nanopol 1
CR310 limited to 1 table? Steve 2
checkport (8) at start in CR310 Steve 3
SDI-12 addressing. m.calispa 4
set clock via terminal emulator smile 0
Excessive data usage MAWF 2
FTP Connection kevinclily 1
Parkbus Data Consolidation Via WiFi kevinclily 3
Modbus RTU Master and Modbus RTU Slave in the same port CarlosM 0
CR100x sending multiple SDI-12 command prompts CRC 1
The CDM-VW305 does not respond after sent the new program on CR6 cyril 1
CR1000 unable to communicate brbdogsonfire 3
Call a sub when program is sent to logger jarlu 1