FAQs Häufige Fragen an uns

Fragen dazu Fragen dazu

All FAQs (1768 total: showing 421-440)

Can a PWS100 be used to measure visibility? If so, can it be used in a sandy area such as the Sahara Desert?
What is the current drain of the PWS100?
How is the PWS100 different from a rain gage or snow depth sensor?
Can an HFP01SC-L provide correct running averages if the scan rate is reduced to 1 minute?
If Short Cut does not list the TCAV-L on its sensor list, what should be done?
Is it OK to have a TCAV-L connected to a datalogger using a very long cable (100 ft/30 m)?
What are the measuring range, accuracy, and resolution of the TCAV-L?
What might cause a 25% difference between the factory calibration and the in-situ calibration of an HFP01SC-L?
What type of quality assurance/quality control can be performed on HFP01SC-L measurements?
For the HFP01SC-L, is there an available acquisition program that is capable of running in PipeLineMode?
If Short Cut does not list a heat flux plate on its sensor list, what should be done?
Does the HFP01SC-L have to be in direct thermal contact with the surrounding soil to achieve heat flux readings?
Can the HFP01SC-L be embedded in railroad ballast, which comprises a blend of coarse rock particles?
If the heat flow from the inside of a wall to the outside of a wall is being measured on the outside, should the blue face or the red face of the HFP01-L touch the wall?
If the cable of the HFP01-L gets cut, can the cable be soldered to have the sensor work normally?
What is the exact output voltage of the HFP01-L?
If the speed indicator on a wind monitor stops working, is there a part that can be replaced, or does the whole unit need to be replaced?
Is it possible to get 4 to 20 mA outputs for both wind speed and direction from the 05103-L?
Do the 05103-L and 05103-45-L produce the same output?
Can the output of a wind monitor (05103-L, 05103-45-L, 05106-L, or 05305-L) be changed to analog dc voltage?

Vorhergehendes Nächstes