FAQs Häufige Fragen an uns

Fragen dazu Fragen dazu

All FAQs (1768 total: showing 361-380)

What can be done if a new table is not being baled by Baler?
How can a user start fresh with a new configuration settings file?
Can Baler be used to push data from a Windows server to a Unix server?
What is Baler?
How can RTMC Run-Time be made to run faster?
Is the one copy of RTMC Run-Time that is included with the purchase of LoggerNet only for use on the same system as LoggerNet, or can it be installed on a different system?
What is the difference between the microSD cards that Campbell Scientific sells and the cards that are commonly used in the consumer electronics at home?
Can the CS11-L activate a small relay?
Can the CS11-L be used to measure amperage from a battery?
Can the CS11-L be used in a three-phase power situation?
How can the CS11-L be used on a datalogger other than a CR200(X)?
Can an ST350 be used in instrumental pile load tests with cast-in-situ (bored) concrete piles?
What needs to be done to measure ST350 Strain Transducers using a Campbell Scientific datalogger?
What is the microstrain limit for the ST350?
Is one 4WFBS350 or 4WFBS120 required for each ST350 connected to a datalogger or multiplexer?
When should a guy kit be used on a CM106B?
When the GPSReady variable is not 10, does the data logger still synchronize with the PPS signal?
If the “pps” field returned by the GPS() instruction usually displays “990000,” what might be the cause?
If the “gps_ready” output of the GPS() instruction is stuck at or near zero and the datalogger clock is not being set, what might be the cause?
How can latitude and longitude data from a GPS16X-HVS receiver be recorded on a data logger and then parsed out?

Vorhergehendes Nächstes