FAQs Häufige Fragen an uns

Fragen dazu Fragen dazu

All FAQs (1756 total: showing 1401-1420)

Is an SC32B needed to communicate between a datalogger and a PC?
Should an SC32B be installed between the RS-232 port on a datalogger and the port on a desktop PC to prevent ground loop issues?
Can the SC32B be used with an SDC device?
Why is it important for the SC32B to be optically isolated?
What is needed to set up a communication network for an eddy-covariance system in a remote location?
Can an ENC16/18 be used with an enclosure heater to increase the inside temperature and reduce the risk of condensation?
Can converters to 18 Vac and 12 Vdc be located within an ENC16/18 without affecting the datalogger or data?
Can 120 Vac be brought into the ENC16/18?
How many mounting accessories should be ordered for each major device inside an enclosure?
Is a fiberglass enclosure suitable for an installation in a very cold location monitoring corrosion?
If the copper ground terminals attached to the bottom of an enclosure are oxidized and corroded, how can they be replaced?
What are the distances, center-to-center, of the mounting holes in the back of the ENC14/16?
If the PVC fittings at the bottom of the enclosure have too small an inner diameter to accommodate all the cables passing through, is there a way to remove the PVC fittings?
What is the preferred method for punching a clean hole through the bottom of an enclosure?
Can just the backplate of an enclosure be purchased?
Does the enclosure have a mounting bracket inside to mount the datalogger?
How often should the fuel temperature and moisture dowels be replaced?
Where is there a picture with part numbers for the fuel moisture sensor, fuel temperature stick, temperature probe, and mounting stake?
Is it possible to make a portable system that can use a TDR100, a datalogger, and a TDR probe to sample on command via a switch?
How can both a TDR100 and an SDM-IO16 be connected to a single CR1000 or CR800?

Vorhergehendes Nächstes